Hinge connection error between parts 32494 and 32495c01

Have any problems with SR3D Builder? Discuss them here!
bootknuckle
Posts: 7
Joined: Wed Jan 18, 2012 3:24 am

Hinge connection error between parts 32494 and 32495c01

Postby bootknuckle » Thu May 01, 2014 12:33 am

Hello,

I'm using SR 3D v9.5.9 to build 8297-4X4 Off-Roader. The program does not perform a successful hinge between the steering and axle parts below. I've tried using the connection solver. The type of connection is roughly the same as a that between 92906 (Technic CV Joint Steering - Female) and 32494 (Technic Wheel Spindle Axle Driver).

Parts affected:
32495C01 Technic Wheel Spindle Steering Arm (Complete Assembly)
32494 Technic Wheel Spindle Axle Driver (CV Joint Axle)

Note: 32494 interfaces with 32496 Technic Wheel Spindle within the 32495C01 Assembly.

Can you fix this issue or provide any information on how to resolve?

Video explaining problem



Kind regards,
Trevor

bootknuckle
Posts: 7
Joined: Wed Jan 18, 2012 3:24 am

FIXED: Hinge connection error between parts 32494 and 32495c

Postby bootknuckle » Fri May 02, 2014 10:58 pm

This issue was fixed by Sergio Reano on May 03, 2014.

Instructions:
Ensure SR 3D Builder is not running before proceeding. Copy the attached part to the x:\ldraw\conns folder overwriting existing files should fix the problem.

Solution detail:
The problem was associated with part 32496 (component within 32495c01 assembly).

Replace:
C 5 0 -15 0 0 1 0
C 5 0 15 0 0 -1 0

With:
C 5 0 8 0 0 -1 0
C 5 0 -8 0 0 1 0

Delete:
0 C 5 0 6 0 0 -1 0
0 C 5 0 -6 0 0 1 0
Attachments
32494HingeFix.JPG
32494HingeFix.JPG (47.43 KiB) Viewed 1848 times
32496.DAT
(125 Bytes) Downloaded 121 times


Return to “Support Forum”

Who is online

Users browsing this forum: No registered users and 1 guest

cron